You are here: Home >> News

News

2015-06-05

OPWELD SAW is a system for ultrasonic testing of welds and material properties. The equipment is used in the spiral welded (SAW) pipe inspection.


OPWELD SAW is a system for ultrasonic testing of welds and material properties. The equipment is used in the spiral welded (SAW) pipe inspection.


OPWELD SAW is a system for ultrasonic testing of welds and material properties. The equipment is used in the spiral welded (SAW) pipe inspection.

 

The installation allows for detection:
 - front end pipe testing,

 - second end pipe testing,

 - longitudinal defects detection,

 - transverse defects,

 - heat affected zone inspection,

 - lamination detection.

 

The device allows to carry out all types of measurements described in the EU Standards for automatic ultrasonic examination of steel pipes.

The system contains two independent modules for testing weld and material, supporting respectively 14 and 8 of ultrasonic probes.

The measurement procedures developed on the basis of the recommendations of EN 12668-1 and EN 12668-2 standards.